Soda Stream drying rack (2 Bottles)

This is my own first model made from scratch in Tincercad. It is visually based on model by 3D JOE that was made for 3 bottles but too big to fit on my printer.

It can fit 2 plastic 1l. Slim bottles as well as 0.5l and Syrup bottles. The bottles are a little wobbly and too close to each other, but if your kitchen don't shake all the time should not fall off. (Its generally working for me, even if first vesrion is not that perfect).

Printed on Anycubic Kobra 3 V2

Manual tree supports for ends of the beams (they are made thinner at the end to fit in more easily), may need to be trimmed after printing.

They can be printed vertical, but will be weaker and it increase print time in exchange for no supports and better overall look.

General 0.2 mm setting should work just fine, but I would add wall loop: 3 for more durability.

Warning!

This is Newbie design and may not work correctly or cause issues. You use it at your own risk. The appearance and design is not that good and could use some tweaks.

Print time: 2h 26m

Filament used: 68,16g