Staircase Lighting 45 degrees

A complete led armature for underneath your steps that allows you to use 5mm led strip (or resize in your slicer) and tuck the cable away behind the risers.

Just print them as is. In the photo the body is black and the diffuser is white, this works perfectly for no light bleed.

Recommended printing settings using a Kobra S1:

• Body:0.08mm layer height, standing up (this can take a very long time to print). Also make sure you add supports for the hole, i used tree supports.
• Endcap: 0.08mm layer height
• Diffuser: 0.12mm layer height

For the endcap

It's a tight, really tight fit, once it's in you will not get it out without destroying the armature. I used a hammer to get them in ;)

To mount

Us double sided tape, but please stay away from the AliExpress cheapo's. If you run your led strips at 100% for a while they radiate a bit of warmth and the cheapo tape comes loose. Can recommend 3M

For my setup i used (no affiliates, just an impression :) ):

• 24v Led Strip https://amzn.eu/d/0exalilS
• Cable https://amzn.eu/d/0eldmoSz
• Zigbee Controller: https://amzn.eu/d/05a5TXB0
• White PLA for diffuser: https://amzn.eu/d/044mb2Hg
• Black PLA for the body: https://amzn.eu/d/09wsuFVm