Stranger Things - Eddie Munson - HueForge

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

 The Model is 150x150mm in size

 You may print at higher layer heights below the Base Thickness of 1.04mm

 The Max allowed Thickness is 2.8mm and the Actual Thickness is 2.8mm

#000000 PLA+ Sunlu Black Transmission Distance: 0.6

#0f52ba PLA+ Sunlu Blue Grey Transmission Distance: 3

#d22332 PLA+ Sunlu Red Transmission Distance: 6

#ffd500 PLA+ Sunlu Pure Yellow Transmission Distance: 5

#ffffff PLA+ Sunlu White Transmission Distance: 5

This print uses 5 unique filaments

Swap Instructions:

Start with Black

At layer #14 (1.2mm) swap to Blue Grey

At layer #16 (1.36mm) swap to Red

At layer #21 (1.76mm) swap to Pure Yellow

At layer #27 (2.24mm) swap to White for the rest.