TEC 9 Historical Prop

我每周五上传一个新设计

Don't forget to "Click A Like" & check out my other Cool designs and Follow my Weekly dose of KooKoo uploads, PLZ leave a comment what you want next! Also dont forget to look at my other 800+ designs ;)

The Intratec TEC-9 was one of my favorite movie guns from the 1990's it was seen on Miami Vice as well as other TV shows and movies its a very iconic gun usually used by the bad guys, this little project brought back awesome childhood memories I hope you enjoy it as much as I have.

Prit Instructions

YES Supports Required, YES Brim or Raft required, Quick and easy print, very simple assembly!

BOM:

PLA Filament

2x M5 screws (upper and lower receivers)

2x Compression Spring 4.5 mm OD x 16mm L (trigger, magazine release)

2x 1.5mm pins x 36mm (trigger, magazine release)

12mm OD x 30mm L Compression Spring (bolt)

Superglue to join the upper components after inserting the bolt (Make sure you insert the bolt spring before you glue the parts together)

Print Settings:

0.2mm layer

6 Walls/Shells

20% Infill

Print Time:

less than 24hrs

Material Used:

Anycubic Silk PLA GRAY

Anycubic PLA+ BLACK

If you are interested in other prop firearms, Airsoft parts and designs do join our group on Matrix:

https://app.element.io/?pk_vid=f12152aac29bbc4a166549437941781a#/room/#GCI-General:matrix.org

!!!Note: I'm always open for suggestion and help on improving the design and proof of concept.