0
0
:
0
0
:
0
0
:
0
0
Celebrate 11 Years with Anycubic: Capture Your 3D Printing Moments.
Makeronline
2026-09-17 19:54:53
248
2
Report

TrackTwin – Foil T-Nut Holder & Spacer (165mm)

@3DMaddin_408027
Message
Follow
Recommended printing method
Description

TrackTwin – Foil T-Nut Holder & Spacer (165mm)


💡 Concept: Say goodbye to lost T-nuts inside your hydrofoil track boxes! The TrackTwin system connects both T-nuts at a fixed 165mm spacing, keeping them perfectly aligned and making foil mounting on your board faster, cleaner, and effortless. It prevents nuts from sliding around or flipping over inside US-box tracks while acting as a precise spacer guide for consistent foil positioning every session.

 

✨ Key Features:

  • Perfect 165mm Spacing: Holds two track nuts at exact distances for quick M8 / M6 foil mast plate alignment.
  • Fits Standard T-Nuts: Designed to hold brass or stainless steel track nuts with a width of approximately 18.5mm.
  • Ultra Lightweight: Weighs only 7.14 grams each —zero noticeable extra weight on your setup.
  • Super Fast Print: Takes less than 3 minutes each to print!


🎯 Recommended Use:

  • Hydrofoil board setup (Wingfoiling, Windfoiling, Kitefoiling, SUP Foil, Surf Foil).
  • Keeps T-nuts connected together in US-box track channels so they stay in place when removing or installing the foil baseplate.
  • I use it for my GONG wing foil setup and my Indiana wing foil boards.


📝 Notes and Tips:

  • Material Recommendation: Since this accessory will be exposed to outdoor conditions, UV radiation, and water pressure, PETG-CF (Carbon Fiber Reinforced PETG) is highly recommended for maximum stiffness, durability, and a clean matte finish. Standard PETG or ASA also works well. 
  • (Avoid PLA for long-term outdoor water exposure).
  • Print Settings: Use 100% infill or 4+ wall perimeters for maximum structural strength along the thin flexible bridge.
  • For older 3D printers please use a border (print adhesion).
  • This model is designed for decorative use – not a toy
  • Please remove the supports carefully.
  • Use dry filament and a clean print bed; it's best to clean the print bed with Isopropanol
  • I use also the cool plate
  • Print multiple copies at once to reduce waste.


🔔 Caution: 

  • I printed and field-tested this model myself on my Kobra X printer without any issues. Minor adjustments to scale (1–2%) may be needed depending on your specific T-nut dimensions and filament shrinkage.


🌀 Used Filaments:

  • OVERTURE PETG - Digital blue
  • ERYONE PETG- CF - black


Of course, I'll be releasing more models soon!

I'd be very happy if you'd follow me.

I would also be very happy about a comment or a “thumbs up”!

Of course, I would also be very grateful for a small donation for my work.



Tags
hydrofoil
hydrofoil track plug
wingfoil
wingfoiling
wingfoilpump
foil
track
t nut
Holder
nut stone spacer
nutenstein
us box
tracktwin
165mm
water sports
surfing
surfing accessories
windfoil
License