Ultimate Laptop Stand - no glue needed!

💫 Introducing the ultimate laptop stand 💫

After printing other stands on here i found that they were too flimsey or not big enough for my laptop. I decided to make this one to fix that issue and to hopefully help you too!

I have split it into parts so it is easy to print and even easier to put together! Just snap it all together and done, it holds itself together (surpringsly well!) by friction!

To print you just need the following amount of your chosen sized components:

2 x side pieces

4 x connectors

You choose which sizes you want depending on your particular laptop size. The connecting pieces measurements are from edge to edge. If you want to know the distance it will be from side piece to side piece then you must remove 4cm. 20 or 25cm would be the “standard” size for most laptops but I have included a wide range of sizes to fit all laptops and print beds ;)

Have fun and enjoy!

✨If you like what I make ✨

• Like, follow, comment, share, review, and post your makes
• Check out my other models! :)