Ventilation unit [Requires drone motor]

Ventilation unit for drone motor. Made for multistar 2213-935. May fit other drone motors. Requires 16x19 screw arrangement on the back.

Requires Arduino, Potentiometer, Drone motor, ESC, Two Switches, Wires, Soldering Tool.

Wiring:

Arduino to ESC

• ESC Signal Pin connected to Arduino Pin 9 (PWM output for motor control).
• ESC Ground Pin connected to Arduino GND.
• ESC Power Pin connected to a power supply (not directly from Arduino; use a separate battery or 5V supply suitable for the motor).

Arduino to Potentiometer:

• Potentiometer Signal Pin connected to Arduino Pin A2 (analog input).
• Potentiometer Power Pin connected to Arduino 5V.
• Potentiometer Ground Pin connected to Arduino GND.