ZioG The Frame

The ZioG Frame is here!

I am passionate about PC and 3D printin and i wanted to fit my ATX PC in the Ikea Kallax cube and, believe it or not, there is no ATX option ready to go.

NO PROBLEM!

I designed my own open frame to fit my PC in the Kallax and you know what? I like it! This is why then i went through an iterative optimization until this point. It is not perfect BUT quite ok. And it is also techno viking approved.

Main features:

• good compromise between compact design and aesthetic
• you can hide almost all your cables behind
• the PSU vent gives more support to the mainboard but it is optional
• on top there is a small handle which helps you to move it and to hold some small accessory cable
• the round logo is optional

Requirements

Read carefully!!

• it requires an SFX PSU, a standard one will not fit
• it requires a turning on wired or wireless button (i use a PCI remote)
• once you fit all the M3 heat insert, screw into each one a screw to remove the plastic residuals

Hardware needed

In order to be able to assmble TheFrame you need:

• 8x M3 mobo riser (around 6.5 mm high)
• 15x M3x18
• 3x M3x14
• 3x M3x10
• 34x heat insert M3 (max length 5 mm, a bit less if you use the full cable covers)

Available configuration

Quick guide on the configurations available (more details in the guide):

• BASE configuration, print [01, 02, 03] for the structure plus [04 OR 05 and 06] if you want respectively full cable covers or bridged cable covers:

• STIFF configuration, print [01, 02, 03, 10, 11] for the structure plus [04 OR 05 and 06] if you want respectively full cable covers or bridged cable covers:

• AIO STIFF configuration, print [01, 02, 03, 10, 12] for the structure plus [04 OR 05 and 06] if you want respectively full cable covers or bridged cable covers:

How to assemble

Thanks!!