urban Goku hueforge

Donate

Message

Recommended printing method

Print Profile Files (1)

Raw Model Files (0)

Add

Designer

/ Plates:1

/ 33h34m

Description

Project: goku.hfp

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 281.19x500mm in size

You may print at higher layer heights below the Min Depth of 0.48mm

The Max Depth is 2.2mm and the Actual Depth is 2.3mm

Filaments Used:

PLA PolyLite Black Transmission Distance: 0.3

PLA BambuLab Basic Blue Gray Transmission Distance: 3

IMAGE #ef4b75 Transmission Distance: 1

IMAGE #f92614 Transmission Distance: 1

PLA PolyLite Grey Transmission Distance: 1

IMAGE #78dfda Transmission Distance: 1

IMAGE #f9f412 Transmission Distance: 1

PLA PolyLite White Transmission Distance: 5

This print uses 8 unique filaments

!!!! It appears you have mixed filament types. Be certain this is what you want. !!!!!

!!!! It appears you have Image Colors as Filaments. It will not be possible to print this. !!!!!

Swap Instructions:

Start with Black

At layer #10 (0.88mm) swap to Blue Gray

At layer #13 (1.12mm) swap to #ef4b75

At layer #14 (1.2mm) swap to #f92614

At layer #15 (1.28mm) swap to Grey

At layer #17 (1.44mm) swap to #78dfda

At layer #20 (1.68mm) swap to #f9f412

Border Only Colors from here until the end.

At layer #24 (2mm) swap to White

This slider is set higher than the mesh depth. It is not affecting your final mesh. Consider removing it.

At layer #32 (2.64mm) swap to Black for the rest.