2026-04-16 03:59:24
372
2
Baxi Duo-Tec Compact boiler Condensate Trap screw cap
@DIYAnanas_5547944
Donate
Message
Follow
Recommended printing method
Add
screw-18-1-5-thread any
Kobra 3
Kobra 2
、
Kobra S1
、
Kobra 4
、
Kobra X
、
Kobra 3 V2
、
Kobra 3 Max
、
Kobra 2 Max
、
Kobra 2 Pro
、
Kobra 2 Neo
、
Kobra 2 Plus
/ Plates:1
/ 1h22m
0
Share
Description
This is a replacement screw cap for the Baxi Gas Boiler. The condensate trap has a screw that you can unscrew if you want to flush and clean it. The original one had formed a crack and was leaking condensate water. After measuring the thread it seems it is a M18x1.5 screw thread. After some model tests while being a snug fit. It's a good replacement in a pinch.
Recommended to print in PETG or stronger filament. Since This sits near the gas boiler and the condensate water is usually warm/hot. I reused the original rubber gasket from the broken screw. But I measured and just added a simple on to print if needed in TPU.
Three shapes added for preferred use.
Tags
License
