Dr.Doom
This print was inspired by the iconic armor-plated look of Dr. Doom. I wanted to capture his cold, mechanical aesthetic with clean surfaces and precise rivet details, and the Kobra S1 Combo handled it beautifully.
๐จ๏ธ Printer & Settings
- Printer: Anycubic Kobra S1 Combo
- Material: PLA (standard grey)
- Filament Used: 238 grams
- Infill: 10 %
- Print Time: 9 hours
- Layer Height: 0.2 mm
- Support: Minimal (chin and mouth areas)
- Bed Adhesion: Standard textured bed, no warping
โก Performance
The Kobra S1 Combo maintained great consistency throughout the print โ no stringing or layer shifts, even with the maskโs overhangs around the cheek vents and mouth grille. The details around the rivets came out crisp, showing off the printerโs accuracy.
๐งฉ Post-Processing
The mask came right off the build plate with a smooth matte finish. A light sanding and metallic paint job will bring it even closer to the authentic Doom armor look.
๐ฌ Final Thoughts
This print proves how capable the Anycubic Kobra S1 Combo is for detailed cosplay and prop projects. If youโre into character masks or large wearable prints, this setup handles long print hours with reliable precision.
