Dragon Coaster

Another dragon coaster!

No ACE pro required, only a single colour swap which can be done manually!

ACE Pro filament swap included in the profile.

To clear any stringing (often inevitable on these 0.08 height prints, especially with wetter filament), just quickly go over the model with a lighter or hot air gun.

0.08mm layer height and 100% infill strongly recommended!

Swaps:

• Start with Black filament
• On layer 14 (height 1.2mm) swap filament to White

All my coasters use the same height swap, so you can easily print multiple on the same plate and only swap once!