Kobra 3 Max Wyzecam Side Mount

Side mount for camera with adjustable angle on the top mount, uses a clip to hold it in place. Mount the base first, which is a *very* snug fit around the foot of the printer. If it doesn't seem like it's going to slide on, it will. The cable runs through the base to keep it tidy. There are a number of ways to mount this. I've printed it with supports on the base and without. The clip can be removed and the top angle adjusted anytime. Put the base on first, then put the camera/top plate on last.

Update 4/3/2025: Moved the post a little farther (10mm) away from the bed/printer. Flipping the plate was a little troublesome with it that close.

Update 6/2/2025: Added an extension (different profile) for those who want the camera higher. Can print the extension and add to the current print so you don't have to print the base and top again.

NOTE: Also have a top mount camera that fits K3 or K3 Max.

https://www.makeronline.com/en/model/Kobra%203%20%2F%20Kobra%203%20Max%20Wyzecam%20Top%20Mount/169804.html