2026-07-09 21:16:33
5k
449
Kobra X and Kobra 4 Stray Redirector
@rrmccabe_2417403
Donate
Message
Follow
Recommended printing method
Add
Main Print
Kobra X
Kobra 3
、
Kobra 2
、
Kobra S1
、
Kobra 2 Plus
、
Kobra 2 Neo
、
Kobra 2 Pro
、
Kobra 2 Max
、
Kobra 3 Max
、
Kobra 3 V2
/ Plates:1
/ 1h18m
140
Share
Description
Worried about filament strands falling off the back of your build plate near the nozzle wiper and into the Y axis slot? It happens. I just took off my bottom cover recently and was surprised the amount of filament debris in there. We created a small ramp/platform to catch the small extrusions and keep them from dropping inside your printer.
Simple to install and takes about 2 minutes. 'Remove the four screws holding your bed on using a 2mm allen driver. Sit the bed aside and snap the offramp around the left rear mount as show in picture. Install your bedplate again with the four screws. Done
This is designed to be printed in PLA. Make sure you clean all the support material off around the fin so it locations properly.
Raccoon Engineering Website Link
Tags
License
Standard Digital File License
This work is licensed under the Standard Digital File License.
You are prohibited from sharing, sub-licensing, selling, renting, hosting, transferring, or distributing the digital file or 3D printed versions of this object, as well as any other derivative work in either digital or physical form (including remixes).You are not allowed to use the objects in any manner that involves charging money or collecting fees without permission.
You are prohibited from sharing, sub-licensing, selling, renting, hosting, transferring, or distributing the digital file or 3D printed versions of this object, as well as any other derivative work in either digital or physical form (including remixes).You are not allowed to use the objects in any manner that involves charging money or collecting fees without permission.
Comments & Ratings
Here is empty
Remixes
