Magnet Dispenser & Tool Holder - SKADIS

After discovering Brian Dean's magnetic dispensers, I needed a place to keep them. There were other models, but they didn't have the sizes I needed. I created this to fit this set of magnets which has the larger 10, 12, and 20mm diameter magnets as well as my deburr tool, some extra blades, and a small screwdriver. 

The file I am attaching has 2 plates, with the 2nd plate just being the first version of the model. It works fine too, but the holes for the smaller tubes were a little close, causing the caps to press against each other. It was purely an aesthetic choice to adjust it a little, and while I was in there, I added the size numbers.

Filament is Creality Hyper PLA in White.