Seat Ibiza (Hueforge)

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

 The Model is 200x200mm in size

 You may print at higher layer heights below the Min Depth of 0.24mm

 The Max Depth is 2mm and the Actual Depth is 2.1mm

Filaments Used:

PLA PolyTerra Charcoal Black Transmission Distance: 0.3

PLA Protopasta Silver Smoke Grey Transmission Distance: 20

PLA Protopasta Spittin' Seeds Gray Transmission Distance: 16

PLA Kingroon White Transmission Distance: 5.8

This print uses 4 unique filaments

Swap Instructions:

Start with Charcoal Black

At layer #7 (0.64mm) swap to Silver Smoke Grey

At layer #12 (1.04mm) swap to Spittin' Seeds Gray

At layer #18 (1.52mm) swap to White for the rest.