🐰🥱💤Yawning Rabbit💤🥱🐰

Maximum Cute, Minimum Supports!

Inspired by those Monday mornings when even your alarm clock gives up, meet the Yawning Rabbit! A adorable little buddy engineered to add some cozy, sleepy vibes to your desk setup.

The best part? You don't need a PhD in 3D printing to slice this soft boy!

🛠️ Print Settings & Quick Tips:

• Difficulty: Beginner-friendly. Easier than waking up at 6 AM.
• Supports: Minimal required. We optimized the geometry to keep filament waste low and cleanup stress-free. Just throw in a few light tree/organic supports right under the chin/mouth cavity and below the lifted paw. The rest prints like a dream—no awkward overhang drama!
• Recommended Layer Height: 0.16 mm – 0.20 mm works like a charm. If you’re printing with a nice matte or silk filament (dusty rose looks stunning!), dropping down to 0.12 mm will give you that butter-smooth finish.
• Infill: 10–15% Gyroid or Grid is plenty. He’s here to yawn, not to support structural loads!

Fire up your printer, drop a print, and share your makes... before he falls back asleep! 🐰💤