Anycubic Kobra X Spool Holder Wall Mount – Front & Side

Two wall-mount options for the Anycubic Kobra X spool-holder system, supplied together in one ready-to-print 3MF project.

INCLUDED VARIANTS

• Front Mount – the spool axis points straight out from the wall. Approximate model size: 54 × 120 × 49.6 mm. Four Ø5.5 mm mounting holes.

• Side Mount – the spool axis runs parallel to the wall. Approximate model size: 136 × 140 × 59.6 mm. Three Ø6.0 mm mounting holes.

Each variant is placed on its own plate and saved in the intended print orientation. Both models are designed to print without generated supports. The three horizontal mounting holes in the Side Mount are designed to bridge without support.

The bayonet interface has been physically verified with the compatible adapter. The two wall mounts are independent compatible accessories created from new geometry. No files or model geometry from the linked designers are included in this upload.

REQUIRED COMPATIBLE SPOOL-HOLDER SYSTEM

This wall mount is designed to connect to the OEM Threaded Adapter from Kobra X Spool Holder by FeralLycan. Download the required spool-holder parts separately from the original model page

OTHER PARTS SHOWN IN THE PHOTOS

Some photos also show the following separately downloaded designs. They are not included in this upload and are credited to their original creators:

• Anycubic Kobra X Spool Mount by RockDar (Makerworld)

• KOBRA X – Spool Spinner Bolt – Knurled by Yablonsky

INCLUDED PRINT PROFILE

Profile name: 0.24 mm PETG – 5 walls – 12% Gyroid – No supports

• Printer preset: Anycubic Kobra X 0.4 nozzle

• Material: PETG

• Scale: 100%

• Layer height: 0.24 mm

• Wall loops: 5

• Sparse infill density: 12%

• Sparse infill pattern: Gyroid

• Enable support: Off

• Nozzle temperature: 250 °C

• Textured plate temperature: 65 °C

Use screws and wall plugs suitable for the wall material and expected load. Check that the mount is firmly attached before installing a filament spool.