Creeper Clicker V2

This is a remix of my original creeper clicker, to make it easier to assemble! The body is now one piece instead of two, and there is more clearance inside the head to reduce any parts scraping together.

PARTS:

You will need one keyboard switch in a cherry mx format or similar. Print all 3 files (eyes and mouth, head, body).

ASSEMBLY:

The eyes and mouth fit into their grooves in the head, you might need glue to keep them secure.

Push the keyboard switch into the base as shown in the photos, and pop the head on like a key cap. No need for glue, it should fit snugly.

PRINT SETTINGS:

Supports optional on the head (position upside-down on print bed), not needed on the body (position upright standing on feet).

Any layer height and infill, 3 walls.

Adjust x-y hole compensation if the switch isn't fitting properly.