Denture Bit Holder

Denture Bit Holder (28 Bits) – Print in PlaceA fun, functional, and striking bit organizer shaped like a set of dentures! Designed to hold up to 28 standard bits, this holder opens and closes smoothly using a Print-in-Place hinge (no assembly required for the joint, it prints all in one piece!).

Key Features:Capacity: Holds up to 28 bits (14 top, 14 bottom).

Print-in-Place: No complex joint assembly needed, ready right off the build plate!

Magnetic Retention: Magnet pockets keep both the case closed and your bits securely in place.

Hardware Required:To complete the model, you will need:

2x 10x3 mm Magnets (for the main hinge / closure)

28x 4x1.5 mm Magnets (inserted into each bit slot for secure hold)

Recommended Print Settings:Supports: No supports needed

Layer Height: 0.20 mm

Infill: 15–20%

Material: PLA or PETG

If you like this model, please leave a Like 🧡 and upload a picture of your print! Happy printing!