Flourish Light Switch Cover

Title: Ornate Victorian Rose Decora Switch Plate Cover (Fits Over Your Existing Plate)

Description:

Give a plain light switch a vintage, antique-brass look without replacing anything. This ornate rose-and-scroll frame slips right over a standard single Decora (rocker) wall plate and screws on with longer screws. Your original certified plate stays in place underneath.

Why a cover and not a replacement plate?

Your original plastic plate stays on the wall, so the electrical box stays properly enclosed by a certified plate. This print is purely decorative, and you don't have to worry about whether your filament is rated for electrical use.

Fits:

• Standard single-gang Decora/rocker wall plates, about 70 × 114.3 mm and up to 7 mm deep (tested on a Leviton plate)
• Standard Decora screw spacing (96.8 mm / 3-13/16")
• The pocket has 0.5 mm of clearance per side, and the edge is angled slightly so the first layers of the print don't make it too tight

Size: 97 × 125 × 15 mm

Hardware:

• 2 × #6-32 flat or oval head screws, 5/8" long (your original screws will be too short)
• The countersunk seats let the screw heads sit flush in the decoration. Brass or antique bronze screws finish the look nicely.

Print settings:

• Material: PLA or PETG. Silk gold PLA looks amazing, and PETG holds up a little better under constant screw pressure.
• Orientation: back face down, as oriented in the file
• Supports: inside the back pocket only ("touching build plate only" works). The decorative front needs no supports.
• Walls: 3–4 for strength around the screw holes
• Layer height: 0.12–0.16 mm brings out the rose detail

Installing:

1. Remove your plate screws (the plate stays on the wall).
2. Set the cover over the plate.
3. Screw it on with the longer screws. Tighten until snug. Don't overtighten into plastic.