Impossible Pass-through Fidget

Description

Impossible Passthrough Fidget

This is my impossible passthrough model. Please follow below instruction for installation. 24 pcs D4mm*2mm magnets are necessary.

 Installation Instruction

1. Glue 6 pcs of magnets into the cavity of the top cover. pay attention to the direction of the N & S of the magnets.

2.Glue 6 pcs of magnets into the cavity of handle. pay attention to the direction of the N & S of the magnets.

3.Glue magnets into the cavity of the slider. pay attention to the direction of the N & S of the magnets.

2pcs for one side are recommended. You can have 4pcs or 6pcs for heavier attract force.

4. press in below component

5. insert below component into handle. spring side up.

6. press in the trigger. 

7. insert the slider in.

8. install the small component at the end of the bar.

9. press it into handle. Pay attention to the angle of it before you press it .

10. press cover on. similar with the step 9.

Done!!! Have a fun！