2026-04-04 23:41:35

Kobra X Camera Mod

打赏

私信

关注

推荐打印方式

打印配置文件 (1)

原始模型文件 (1)

添加

Designer

/ 分盘:1

/ 9m

描述

This model is still in development, so any comments or suggestions are welcome. It prints without supports, takes under 10 minutes to print, and uses only 1.23 g of filament.

The clips that hold the model to the printer are somewhat fragile. Once installed, if you remove them, they may break and you will need to print a new one.

⚠️AI foreign object detection doesn’t work, you need to turn it off⚠️

The AI spaghetti detection has not been tested.

Installation tutorial