Leg0 Wreath Flower Cap

This is a remix of Leg0_Wreath_Daffodil_Middle.stl from Ellisse05 at Thingiverse. Link here: https://www.thingiverse.com/thing:6418361.  I wanted these to actually slide onto the flower without gluing them together. So I remixed the model and I bring to you a cap for all of your flowering needs! 

I printed these on 0.16mm High Quality

Initial Layer Height - 0.16

Initial Layer - 0.48

3 Walls

10% Infill

Gyroid Infill Pattern

I also used some generic dual color silk PLA for mine too. Orange and Red. Very nice turn out. 45 minutes to print 6. 

You might have to rotate the model 180 degrees on the Y axis to allow for a support-less print.