Sad Pikachu Clicker Fidget

Description

INTRODUCING MY FIRST CLICKER FIDGET KEYCHAIN FROM THE CUTIE COLLECTION - THE SAD PIKACHU CLICKER

Simple & quick to print, print many on a single print bed & minimise waste

Easy and quick to assemble require a simple Cherry MX switch, Keychain & a small amount of superglue

Cute small & easy to carry anywhere, perfect for stress on the go

A simple addictive click to satisfy your fidget urges

Requires a single keychain found easily online (25mm) and any single generic Cherry MX switch such as the ones here -

BUY CHERRY MX SWITCHES

PRINT SETTINGS

Gyroid infill recommended

0.16 layer height or less for improved print quality

Seams to the rear of the print for improved facial quality

Supports enabled for critical regions (optimised in the supplied print profiles)

In rare cases sometimes the bottom of the top section (the circle surrounding the plus slot underneath the top of the clicker) can over extrude due to the elephants foot setting, this causes the clicker to stick when pushed down, in this case carefully score the circle surrounding the plus slot. This is due to over extrusion creating a mini brim which catches inside the clicker, removal of this mini brim using a scraper will fix the issue

BUILD INSTRUCTIONS

Remove all supports

On the bottom of your Cherry MX switch carefully remove the brass pins using a cutter or simply fold flat

Insert the top of the clicker into the plus shaped top of the Cherry MX switch

Carefully superglue the bottom on the Cherry MX switch into the slot of the clicker base ensuring the front of the Pikachu clicker is facing the front of the Pokeball & straight

Insert your keychain into the slot on the rear of the clicker & try your new Pikachu clicker