Torre Pot, Stackable planter

I hope that this stackable desing helps you to put a bit of green on your life

PETG recommended

• Tested with 3 floors, but although it can handle more then you will need to check how you are going to irrigate the lower floors.
• The base is not mandatory, specially in the outside.
• Two files. The first is for the pot floor, the second is the base. Print as many floors as you want.
• Feel free to scale if you need it, but remember to put the same value in the two files.

Print Instrucctions

• 0.2 layer height, but you can also use a higher value
• 3 walls arachne
• 0.2 infill gyroid or cubic
• 1mm bottom and top