A Christmas Winter Train Music Box

This is a music box for the wind up music box sold everywhere

The sign can be changed easily and requires no glue to secure it to the frame. There is a blank plate, in case you want to personalize it.

Assembly instructions:

These are the pieces you will have. Since then I added other things (post and sign, as well as coal.. because I was bad and did not get gifts :(

Secure the kit to the box, and glue the magnets in. Be careful with the polarity.

Attach the magnets to the snow terrain. Use the box magnets to determine the polarity. Allow the glue to fully set, and check the fit.

Attach the little semicircles. I did not use glue since it gripped it on its own.

Attach the wheels, use the facedown side for extra quality look. There is also a little wagon included, glue the wheels on. Position the Train and car on the tracks and glue it.

Attach the little cloud

Attach the white tree top to the tree. There is one with and one without a hole, pair them appropriately.

Next up, the tracks. They are a little off center… lets say i wanted them that way!

Attach the ice. If you do not have transparent blue, you can use light blue or white

The candy cane is not a real spiral, it is just a series of pauses and filament swaps. It will make a lot of poop hehe, but I think it is well worth it! Attach the candy cane. The flat top needs to stay up, there is only one way it will fit in the base.

Attach a magnet on top of the Candy Cane. Attach the other magnet to the sign box so you can freely rotate it.

Finally, if you were bad, glue the coal to the rear car.

There are two containers available, one with the wood grain takes a long time to print. Choose which one you want, depending on what aesthethics you are going for. The smooth one with Gold Silk would look real nice for example! It is included in the profile, however it is disabled. Simply enable it in the objects section.