0
0
:
0
0
:
0
0
:
0
0
Celebrate 11 Years with Anycubic: Capture Your 3D Printing Moments.
Makeronline
2025-12-10 04:44:49
2.3k
147
Report

Adjustable Phone Stand , Handyhalterung

@wael_diy_1276799
Message
Follow
Description

You stop here cause you have just found the ultimate phone Stand you were looking for xd.

The Gears rotate so will that it is just like a fidget spinner lol. 


The Whole body with the hinge is print in place . put it on the side so the small hole for the small gear is facing up. very important since the Hinge design is very optimized to print this way.

then slap the gears on it and here you have it. 

Support is not needed

The Tow parts that goes on side to hold the phone should be glued if not really holding there.

the Picture of my make is old version so yours will look like the modell. 
i will be making another set of the side parts for smaller phones.
also one version with mag safe is coming so be tuned and follow for more. 
Tags
phonestand
handy
phoneholder
handyhalter
handyhalterung
License