Bleeding Wall Knife

A knife buried deep in a fresh splatter of blood – this Halloween, it makes every guest stop in their tracks.

The model consists of a flat blood splatter (215 × 250 mm, 5 mm thick) with a blade sinking into it at an angle, and a separate knife handle with a diamond knurl grip and lanyard hole. Mounted on the wall, it looks as if the knife was rammed straight into the plaster and the blood is still running down. Assembled, the knife sticks out about 175 mm.

Perfect for your Halloween party, a spooky adventure, the front door or a horror movie night:

• As a bleeding wall: the back of the splatter is completely flat and mounts in seconds with adhesive strips (e.g. Command / Powerstrips). No holes, no mess.
• Standing on a table, at the buffet or on a shelf: a gruesome centerpiece next to the pumpkins and candy.

Assembly

1. Print the blood splatter and blade together in one go (multi-color: blood red + silver).
2. Print the handle separately, standing upright on its front face. No supports needed.
3. Push the handle onto the blade’s tang until it clicks into place. A chamfered corner makes sure it only fits one way round.

Hauntingly good times :)