CMF Phone 1 - Slider System

The CMF phone 1 - Slider System, a complete rig for taking videos with your new CMF phone 1.

Print everything in PLA or PETG and assemble without glue.

The Design is Modular and every rail measures 17cm.

There are 2 Mounting position and the Phone Rig can slide in and out easily.

Remember to remove the original 4 screws and replace them with 4x M2x6mm to make the sure decoration attaches properly.

DISCLAIMER:

We tested the external decorations on the new MCF phone 1 BUT we didn't run any test about Heat, scratches and damages to the phone.

With the 4x M2x6 screws, the decoration fit properly on the device and has a thickness of 1mm BUT we don't know if it may cause overheating of any future problem to the phone. use it at your own risk.