Circular chess (No AMS, MMU or Glue needed!)

For when standard chess gets too boring.

How to print

Print each piece four times (no need to rotate them BTW).

I would recommend:

• .2 mm layerheight
• No supports
• Consider a brim on the blacks, as these can warp
• I recommend no brim if possible on the white, as they are a pain to remove

How to build

Just put the pieces together as shown in the video linked below. Depending on your print tolerances you may need to smack it a bit with a rubber hammer.

https://youtu.be/_sRKH_G12cg

How to play:

I have no idea, check the Wikipedia page → https://en.wikipedia.org/wiki/Circular_chess

Or play online → https://greenchess.net/rules.php?v=circular