Creality CR-6 SE Hot Bed Cable Brace / Repair

I'm not sure how common of a problem this is but I recently bought a CR-6 SE and the plastic stress-relief part near the bed was broken near the screw holes. Unfortunately, the cable isn't easily detachable from the bed so rather than replace the whole bed, I decided to try modeling a repair. The result is a "brace" that wraps around three sides and glues to the broken part of the cable.

I used Gorilla super glue but it remains to be seen if it will hold up (Update: 2 years later and it's still holding strong). Epoxy might be a better bet. I also recommend printing this with something stronger than PLA like PLA+, ABS, or PETG. I used PETG myself.

You'll also need longer screws to use with this. M3x12mm works perfectly.