Credit Card Gyro (Print-In-Place)

I made this Credit Card Gyro as a print-in-place fidget that is about the same length and width as a normal credit card, so it slips into a pocket and stays ready to spin. The part I like most is how sleek it looks when it pops in a bright color. I also like the triple-color option, with black on blue on black for a little sandwich effect.

Print settings:

• Infill: 5%-30%
• Perimeters/Wall Loops: 2-3
• Brim/Raft: NO
• Filament: PLA or PETG
• Listed profile: 1 plate in 38 minutes 13 seconds, using 17.44 g of PLA, with the profile infill set to 7.5%

Tips:

• Calibration is the catch: this one really needs a calibrated and accurate printer, since a print-in-place gyro will not forgive a sloppy first layer or loose tolerances.
• Keep it light if it will not face much pressure, and add infill if you think pressure will be applied.

My Patreon page is still available at patreon.com/MasterPrinter, but I do not actively update it anymore.

You may also like:

• Super Fidget Hexagon Twist https://www.makeronline.com/en/model/Super%20Fidget%20Hexagon%20Twist/156358.html
• Triangle Super Fidget https://www.makeronline.com/en/model/Triangle%20Super%20Fidget/167631.html
• Square Super-Fidget (Print-In-Place) https://www.makeronline.com/en/model/Square%20Super-Fidget%20(Print-In-Place)/158453.html
• Hexa-Triangle Super Fidget https://www.makeronline.com/en/model/Hexa-Triangle%20Super%20Fidget/170413.html
• Tri-Hexagon Super Fidget (Print-In-Place) https://www.makeronline.com/en/model/Tri-Hexagon%20Super%20Fidget%20(Print-In-Place)/167960.html