Gyroscopic Fidget Ring (2 in 1 Fidget)

My Gyroscopic Fidget Ring is a 2 in 1 print-in-place fidget that sits on my finger and spins, and when I take it off it works a lot like the popular gyro. It combines a very nice aesthetic with a smooth fidget, and it works right off the print bed with no assembly.

Print settings:

• Infill: 100%, though it is very minimal so it really does not make much of a difference
• Infill type: Rectilinear
• Perimeters: +2
• Filament: PLA or PETG, really whatever suits you
• Listed profile: 9 plates in 2 hours 29 minutes 41 seconds, with the first layer slowed down for better results

Tips:

• Getting the right size is the catch. There are 9 provided sizes, and the average size prints in less than 8 minutes.
• A ring that does not fit your finger will not be much fun to wear.
• The 16mm ring size measures 23.33 x 23.33 x 8.35, and for a custom size, start with 16mm, measure the inner diameter, then halve your measured finger size before entering it, because the slicer takes the radius, not the value you measured.

My Patreon page is still available at patreon.com/MasterPrinter, but I do not actively update it anymore.

You may also like:

• Credit Card Gyro (Print-In-Place) https://www.makeronline.com/en/model/Credit%20Card%20Gyro%20(Print-In-Place)/175167.html
• Super Fidget Hexagon Twist https://www.makeronline.com/en/model/Super%20Fidget%20Hexagon%20Twist/156358.html
• Triangle Super Fidget https://www.makeronline.com/en/model/Triangle%20Super%20Fidget/167631.html
• Square Super-Fidget (Print-In-Place) https://www.makeronline.com/en/model/Square%20Super-Fidget%20(Print-In-Place)/158453.html
• Hexa-Triangle Super Fidget https://www.makeronline.com/en/model/Hexa-Triangle%20Super%20Fidget/170413.html