Handle for M2,5; M3 and M4 tappers

Handle for M2,5; M3 and M4 tappers with movable cap.

Handle is made from PET-G. Hole for M4 bolt was tapped M4 thread. 

Cap should move freely, some glue can be applied on thread of screw.

Part of nut and handle with thread and above the thread in handle should be printed with 0,15 layer high. (All settings applied in G-code)

To mount cap shoud be used M4x15 socket head screw.

Material: PET-G, ABS, ASA etc.

Layer high: 0,3 mostly ( for threads and holding part 0,15)

Support needed.