Must-have update for Kobra 3!
The Z-axis spindle shaft is attached directly to the motor shaft and pushes or pulls on the motor bearing with every movement of the Z-axis. This isn't just bad for the motor, but also affects the quality.
With my adapter, the load is removed from the motor shaft, allowing the Z-axis to rotate with complete ease. This results in a much cleaner surface on the printed model.
For installation, you'll need an F5-12M (5x12x4mm) axial deep groove ball bearing (€1.50-€2.50) and a 5mm washer. Alternatively, you can also use five 5mm washers. This also reduces the load on the motor, but it's not as smooth. Please apply some grease between the washers!
My adapter improves print quality and reduces hardware wear. Therefore, it's essential for the Kobra 3. I've never had such clean prints.
Have fun and good luck!
