Kobra S1 Lid Holder

Kobra S1 top lid holder for use with filaments such as PLA where you need to let the heat escape. Print in place hinges for a quick easy print. To install, simple remove the two screws holder the handle on, insert the existing handle in the new printed holder, and screw the original handle back in place. I printed with PLA using 0.2mm layer height. No supports or brim needed. The .3mf file was generated from ORCA using an Ender 3v3 Plus profile. A .stl and .step file is also included.

Update: I've added a shorter version as well, that allows for a lid opening of around 20mm.

Note: It appears there are different lids out there. If the bottom of your lid is totally smooth, there is a print profile for a 3mm extended version. If your lid has splines on the bottom then all the others will work.

Check out my other S1C accessories:

Door Handle

https://www.makeronline.com/en/model/Kobra%20S1%20Door%20Handle/264967.html?trackModuleType=10

ACE Pro Desiccant Holder

https://www.makeronline.com/en/model/ACE%20PRO%20desiccant%20holder/253163.html?trackModuleType=10