0
0
:
0
0
:
0
0
:
0
0
Celebrate 11 Years with Anycubic: Capture Your 3D Printing Moments.
Makeronline
2025-06-03 01:27:24
828
26
Report

MagWLED-1 Enclosure w/ Power Button

@Julant_2569232
Message
Follow
Recommended printing method
Description

I tried using the file on the MagWLED website for the power button model by ‘James’, but it had a lot of build errors when sliced. Unclear if the issue is the file or my download, but it doesn't seem to be published anywhere else to compare.


I started over from the base model and added a 4mm hole with 2mm extrusion for support and guidance of the button.


Three different height buttons are also supplied - 6mm, 6.5mm, and 7mm - because I couldn't make up my mind which one I liked best.

6mm is nearly flush with the case for reference.


Full case print includes 6.5mm button by default.


I printed everything in PETG HS, but PLA should be fine since this is intended for indoor use only.

Tags
wled
wledenclosure
magwled
License