Orang Screw - Lightweight Camping Anchor

I recreated the design of well-known plastic anchors, modifying the thread to be flat on one side for easier printing. For maximum strength, I used 100% infill, but a lower infill setting may still provide adequate durability. In my tests, the anchor held firm under my body weight (around 80kg), though I haven't tested it with heavier loads or for extended periods of tension.

Print Settings

• Printer Brand: Creality
• Printer Model: Ender-3 V3 SE
• Rafts: Doesn't Matter
• Supports: No
• Resolution: 0.32mm
• Infill: 100%

This redesigned plastic anchor combines ease of printing with strength and functionality, making it a practical solution for various fastening needs. Adjust the infill settings based on your specific requirements for durability.