Rack & Roll: the cutting board holder that rocks!

You know when cutting boards multiply like mismatched socks and invade your kitchen counter like it’s the Coachella of chaos? Well, I said nope. So I created this bad boy: a modular, draining, disassemblable cutting board rack, 3D printed and ready to kick clutter in the face. So useful, even some of my exes would want it back.

🧠 It’s part of my modular kitchen series, which includes:

• 🧺 Sink & Destroy - The washing rack that take no prisoners
• 🧽 Forkageddon - The ultimate rack for utensils and bottles

💦 The base is tilted to drain excess water into a strategic slot. 🧼 It comes in three pieces, so you can clean it without doing finger yoga. 🧩 It’s modular, so you can adapt it, expand it, or just admire it like a kitchen superhero.

📦 Print specs:

• 🧵 Material: PLA
• ⏳ Print time: about 2 days
• ⚖ Weight: ~600g of PLA
• 🛠 Supports: required
• 📐 Layer Height: 0.20mm

🦸♂ In short: this rack is the Batman of your kitchen. No superpowers, but always saves the day. Print it. Use it. Show it off. And if someone asks where you bought it, just smile and say: “I made it, baby.” 😏

💥 Disclaimer: no cutting boards were harmed during printing. Some, however, finally felt appreciated.