Simple low cost low filament bendy door stop
A Simple low cost low filament door stop with a small gap to act as a spring.
2 files. 25.5 mm wide and 10mm wide
Normal settings, Print in place, no supports.
I printed with PLA+ at 10% infill. If you need something stiffer, print with a higher infield.
On my P1S at 10% infill the thin door stop printed in about 15 min and only used 3.5 meters (10.3 grams. For me that's a cost of about .10 cents usd.)
Please "Like", review, follow and upload make.
Commercial license
As of 2/25/24 my designs are no longer allowed to be sold commercially.
Do you want to sell prints of this model or any of my models? You can purchase commercial licensing at Patreon or Buy Me A Coffee. Earring Commercial Liscence is just $3 a month. A full commercial license for all of my designs is just $7 a month.
