Thors Hammer for Logos
You can use this hammer, with any of my logo files, everything is sized to fit!
Right now, you can use my sports themed logo packs, still on Maker, to add to the hammer!
500+ Custom Hammers and exclusive ducks on Patreon.
I do custom logos at request, reach out!
https://www.patreon.com/c/K3DPrint
Please reach out if you need custom logos done!
Here is my remix of the popular Thor's Hammer/Mjolnir file that is floating around. I have edited the mesh to remove the vertical line, as well as several other imperfections. I have oriented it for optimal quality, which does sacrifice a little time, but worth it in my opinion.
Credits:
@ChaosCoreTech (Original Hammer Designer)
@Emp3thy (Hammer Remix)
@3DHummel (Rock Stand - 75%)
Changes:
My remix fixes quite a few issues I had with the original NFL hammers.
- I was able to get rid of the slight line that ran down the middle when printed.
- No more removing a mess of supports from the inside.
- The handle has been changed/re-oriented. This uses a bit more supports, but it provides a clean connection to the bottom of the hammer. I have printed lots of these for friends and family, and we had a few break off at that point. This change seems to end up with a sturdier hammer.
- The “top cap” has had the lettering removed. At 75%, the quality suffered, and this just provides a cleaner look, especially with a textured plate.
- I replaced the bottom cap with a different design, that sits flush with the side of the handle. This helps prevent the top pieces from snapping off.
Check out my Collections!
