Wall display case for small objects

A simple display case for small objects, which you can also hang on the wall. The dimensions are as follows:

h = 245 mm

w= 210 mm

d= 35 mm

The dimensions of each compartment are 200 x 35 mm.

It was printed with Bambulab Copper PLA Silk, following the directions recommended by the bamboo wiki:

- Lower printing speed for the external walls: between 40mm / s and 60mm / s

- Increase the temperature of the hot end: it should be around 230 °C - 235 °C for the best results;

- Acceleration: Normal printing at 5000 mm / s ^ 2 is External walls at 3000 mm / s ^ 2.

Obviously everyone uses their own parameters for PLA Silk, but lowering the speed and acceleration offers better results.