Working Turbo!!!! Works on weed eater engine!!!!

Donate

Message

Recommended printing method

Print Profile Files (0)

Raw Model Files (8)

+ Frequently Used Printer

10.78MB

4.53MB

696.76KB

More profile

Description

If you want to use it to run on an engine I would recommend printing it in a high heat filament. I used two ID-10mm, OD-15mm bearings on the shaft. The shaft that I used was 10mm diameter. Lastly, for the engines exhaust I used a 9mm high heat tube directly into the exhaust side of the turbo.

License

Creative Commons Attribution-NonCommercial

Comments & Ratings

Emoji

Picture

( 0 / 5000 )

Most Likes

Newest First

Most Replies

Here is empty

Remixes