Anycubic Kobra 3 Enclosure

3D Models and BOM for the enclosure I've built for my Kobra 3.

It's a bit on the larger side, but I'm planning to hang filament spools in the back.

This is just the enclosure! The air filter, heaters and coolers are not included yet, I'm going to upload them when I've tested everything a bit more.

Inside dimensions: 600x700x700 (mm)

Outside dimensions: 640x740x740 (mm)

Printable models:

• Magnetic door locks
• Door supports
• Door handles
• Feet supports
• Feet
• Template for the panel corner cutouts and form alignment

Additional parts and models:

• Printhead cooler
• Cooling duct mount
• DIY 25mm airducts/hoses
• Filament purge bucket (not ready)
• External heat exchanger
• Internal heater <- next

When choosing 2020 extrusions it doesn't matter which type they are (V/T), just make sure they have a 5mm hole for a M6 tap.