Keys wall hanger

A keys wall hanger to hang your keys and a top tray, this hanger has 6 keys slots and the tray for your shades, garage remote, or anything that can not be hanged.

Bill of Materials:

• 12 pieces M3x22mm - to secure the key holder bars (2 bolts on each bar)
• 5 pieces M3x32mm - to secure the top tray to the back plate.
• 2 wall nails to hand the plate on the walls OR you can use double face tape if you prefer.

Assembly:

• You only need to screw the bolts from the back of the plate into the tray and hanger bars, each has its own corresponding space to fit in.
• in case you need assistance please contact me for help.

Before you print:

• print plate should be cleaned with soapy water or IPA.
• machine should be properly maintained and lubricated.
• machine should be pre calibrated, Auto bed level, and pressure advance.
• Filament Flow rate should calibrated.
• Filament temperature should be optimized.
• Support filament materials is recommended (as i do most of my prints using support material filament for clean layers and easier support removal)