Mini RGB Light Cube Pixel

**Mini RGB Light Cube**

A compact, beginner-friendly project requiring basic soldering and microcontroller programming. 

**Printing Specs:**

  **Settings:** 0.2mm layer height, 2 walls, 10% infill.

  **Support:** None required.

  **Material:** White filament is recommended for better diffusion, though clear offers a vibrant look.

  **Assembly:** Use 3mm lengths of filament as alignment pins for the walls. Secure with superglue.

**Electronics & Wiring:**

  **Hardware:** ESP32 C3 controller and 0.6m (98 LEDs) of WS2812B LED strip (2.7mm narrow, 160/m).

  **Wiring:** White (GND), Red (5V+), Green (GPIO2). 

  **Assembly:** Spiral the LED strip carefully inside the housing. Use heat shrink tubing on solder joints to prevent pad breakage.

  **Firmware:** Flash with WLED. Set LED length to 98 in "LED Preferences." Use the provided preset file for preconfigured effects.